Brother MFC-9330CDW Owner's Manual page 5

d
Load paper in the tray and make sure:
 The paper is below the maximum paper
mark (bbb) a. Overfilling the paper tray will
cause paper jams.
 The side to be printed on is face down.
 The paper guides touch the sides of the
paper so it will feed properly.
e
Put the paper tray firmly back in the machine.
Make sure it is completely inserted into the
machine.
f
Lift the support flap a to prevent paper from
sliding off the face-down output tray.
4
Connect the power cord
and telephone line
IMPORTANT
DO NOT connect the interface cable
yet.
a
Connect the AC power cord to the machine and
then plug it into an AC power outlet.
b
Press on the control panel.
IMPORTANT
DO NOT touch the Touchscreen immediately
after plugging in the power cord or turning the
machine on. Doing this may cause an error.
c
Connect the telephone line cord: connect one
end of the telephone line cord to the jack on the
machine marked LINE and the other end to a
modular wall jack.
IMPORTANT
The telephone line cord MUST be connected to
the jack on the machine marked LINE.
5