Chapter 3 Operating The Hp Surestore Fc 1Gb/2Gb Switch 16B; Turning The Fc 16B On And Off; Interpreting Led Activity - HP Surestore fc 1Gb/2Gb switch 16B Installation And Reference Manual

Operating the HP Surestore FC 1Gb/2Gb
Switch 16B
This chapter provides the following information:
•
Turning the FC 16B On and Off on page 3-1
•
Interpreting LED Activity on page 3-1
•
Interpreting POST Results on page 3-5
•
Maintaining the Switch on page 3-6

Turning the FC 16B On and Off

To turn the FC 16B on, connect one or both power supplies to a power source, then flip the AC
power switch to "I".
To turn the switch off, turn off both power supplies (if both are installed) by flipping each AC
power switch to "O".
Note:

Interpreting LED Activity

System activity and status can be determined through the activity of the LEDs on the switch.
Note:
The FC 16B includes the following LEDs:
•
16 port status LEDs on the SFP media side (above and to the left of each port) to indicate the
status of each port.
HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference Guide
Removing all power from the switch triggers a system reset. When power is restored, all
devices are returned to the initial state and the switch runs POST, a one-minute system
check.
The LEDs may flash yellow during diagnostic tests, and green, yellow, or orange during
POST. This is normal, and does not indicate a problem unless the LEDS do not return to a
normal pattern after POST or the other diagnostic tests are complete. The orange light may
be referred to as "amber" in other documentation.
Chapter
3
3-1