Installing The Switch In A Rack - HP Surestore fc 1Gb/2Gb switch 16B Installation And Reference Manual

4. Provide power to the switch by completing the following steps:
a. Connect the power cable to the FC 16B power supply and to a power outlet. Ensure
b. Turn on the power supply (flip the AC switch to "I") when ready to supply power to
c. If the FC 16B includes a second power supply, repeat Steps 4a and 4b for the
Note Do not connect the switch to the network until the IP address is correctly set.
For instructions on how to set the IP address, see
on page 2-9.

Installing the Switch in a Rack

This section provides instructions for installing the FC 16B in an HP or Compaq/Rittal
rack.
Figure 2-1. FC 16B Rack-Mounted Switch
HP Surestore FC 1Gb/2Gb Switch 16B Installation and Reference Guide
Installing and Configuring the HP Surestore FC 1Gb/2Gb Switch 16B
the power cable is routed so that it is not exposed to stress.
the switch. The switch automatically runs POST (power on self-test) each time it is
turned on.
remaining power supply.
Configuring and Connecting the Switch
2
2-3