Viewing And Working With Measurements In 3D - Diamond Engineering 6000 User Manual & Setup Manual

Chapter 4 - Using the Data Processing Feature

Viewing and working with measurements in 3D

Press any of the 3D Buttons to View the "Active Register" Data in 3D Using the MatLab Viewing Interface.
Viewing 3D Azimuth Measurements
1. Be Sure there is data in the "Active Register, if there is no data
you must recall data from one of the storage registers or make a
Measurement.
2. Press the "View 3D Az Plot" button.
3. Depending on the size of your measurement and the speed of
your computer it may take up to 2 minutes for your 3D plot to
appear on the screen.
Viewing 3D Az/El Measurements
1. Be Sure there is data in the "Active Register, if there is no data
you must recall data from one of the storage registers or make a
Measurement.
2. You can only view 1 frequecy at a time using the Az/El 3D
Plots, when you press the "View 3D Az/El" measurements you
will be prompted to choose a frequency to view.
3. Depending on the size of your measurement and the speed of
your computer it may take up to 2 minutes for your 3D plot to
appear on the screen.
QUICK TIP: Use the Amplitude plot to get a reference of the
frequency response of the antenna.
Working With 3D Data
Below are a few common functions that you can do with the 3D plots.
To Rotate a Plot- Click Tools -> Rotate 3D
To Print a Plot- Click File->Print
To Label a Plot- Click Tools -> Add -> Text
To save a Plot- Click File -> Save (Saved File compatible with matlab viewer only)
To Export as BMP Image File- Click File -> Export
42
Data Processing Feature