Table of Contents
Advertisement
Chapter 1 - Installation and Configuration
Connecting the platform and vertical actuator.
1. Ensure that the Azimuth of the
tripod is unlocked.
3. Align the colored piece of tape on the
platform with the tape on the tripod head
and insert the platform into the head at a
30 degree angle, the head will automati-
cally lock the platform into position.
Attaching the optional thrust plate-
Attach the Thrust Plate using the 4 includeded
10-32x1/4" Screws. be sure not to overtighten screws
and if using your own screws be sure they do not hit
the metal bearing below.
2.Place the Tripod head in a
horizontal position and tighten the
locking screw (Loosen screw after
assembly)
4. Loosen the Tilt Lock (Pic 2) enough
to allow the platform to tilt and connect
the vertical actuator rod to the platform ,
tighten the locknut to ensure the rod
does not disconnect.
Applies to Acrylic and Aluminum models.
14
Platform Assembly
Advertisement
Table of Contents
