Measurement Controls; Post Measurement Options - Diamond Engineering 6000 User Manual & Setup Manual

Desktop antenna measurement system
Table of Contents

Advertisement

Measurement Controls

Chapter 2 - Sofware Overview
Measurement Controls
Measure Horiz. Sweep- When this button is pressed, the software will begin making measurements by moving the
platform horizontally , then retrieving the data from the network analyzer. The button will remain "greyed out" while the
antenna measurement is in progress
Measure Vert. Sweep- When this button is pressed, the software will begin making measurements by moving the
platform horizontally , then retrieving the data from the network analyzer. The button will remain "greyed out" while the
antenna measurement is in progress
Scan VH- When this button is pressed, the software will begin what is caled a scan sweep, the software will make a
complete horizontal measurement then move to the next vertical position and make another complete horizontal sweep.
this process will continue until the platform reaches the ending vertical position.
Reset Accumulator- When this button is pressed, the software will begin making measurements by moving the platform
horizontally , then retrieving the data from the network analyzer. The button will remain "greyed out" while the antenna
measurement is in progress

Post Measurement Options

Move to Max Signal - When this button is pressed, the software will analyze the measurements you have jsut
made to find the position where the antenna had the maximum gain , the software will then move the antenna to
the maximum signal position.
Proceed to Data Processing- Once you have completed making your measurements and you click this button you
will be taken to a section of the software that will allow you to view/manipulate any prt of the measurement. The Data
Processing section also allows you to view the data in many different formats including , Polar, Mag, and 3D
Export Reg 0 - When you have completed a measurement you can instantly export the data set to an outside file
for the ability to import the data into a speadsheet or use in a 3rd party plotting or processing program.
28

Advertisement

Table of Contents
loading

Table of Contents