Table of Contents
Advertisement
Chapter 1 - Installation and Configuration
Tripod and Elevation Unit Assembly
The rotator unit has been shipped to you either complete in a matter that requires Minimal effort to assemble.
BEFORE YOU BEGIN: Unpack ALL items and ensure there is no damage or missing parts.
-Vertical Assembly
1. Unfold the Tripod and extend the top of the tripod 1/2 way and secure the height adjustment- (Fig. 1)
2. IMPORTANT! Take the grey vertical mount spacer and snap it onto the very top of the tripod
neck(fig. 2) Without this piece your unit will not make elevation measurements accuratly.
3. atttach the vertical assembly onto the top of the tripod using the included hex wrench so the top
edge of the vertical assembly is touching the bottom edge of the vertical spacer. (fig 3)
Fig 1- Extend the Tripod
Fig 3- Attach vertical Assembly-
Ensure the Vertical Actuator Rod
will have adequate clearance and
will not hit the tripod leg.
13
Tripod Assembly
Fig 2- Attach vertical Spacer
Advertisement
Table of Contents
