Installation; Unpacking Oven; Radio Interference; Oven Placement - Amana RCS10TS Owner's Manual

Unpacking Oven

• Inspect oven for damage such as dents in door or
inside oven cavity.
• Report any dents or breakage to source of purchase
immediately.
Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.

Radio Interference

Microwave operation may cause interference to radio,
television, or a similar oven. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in Care and Cleaning section.
• Place radio, television, etc. as far as possible from
oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.

Oven Placement

• Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
• Install oven on level countertop surface.
• Place warning label in a conspicuous place close to
microwave oven.
• Outlet should be located so that plug is accessible when
oven is in place.
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
C
A—For North American (UL/CSA) models, allow at least
2" (5.1 cm) of clearance around top of oven. For
International (50 Hz) models, allow at least 12" (30 cm)
of clearance around top of oven. Proper air flow around
oven cools electrical components. With restricted air
flow, oven may not operate properly and life of electrical
parts is reduced.
B—Allow at least 2" (5.1 cm) between air discharge on back
of oven and back wall.
C—Allow at least 2" (5.1 cm) of clearance around sides of
oven.
Oven Clearances
Oven Stacking
• Oven stacking is allowed using stacking
bracket located on oven back panel top hinge
side corner.
• Using stacking brackets on back panel of
ovens remove screws from stacking brackets and
reattach them to back panel between both ovens
securing them together using back panel screws.
6

Installation

WARNING
A
B