Programming The Oven Control (Electronic Models); Programming Keys; Canceling Mistakes; Qty X2 Programming - Amana RCS10TS Owner's Manual

Programming the Oven Control

Programming Keys

Oven is shipped from the factory for single key programming. To change
the oven default to allow double key programming, see User Option
section. To change the amount of time or the power level for a preset key:
1. Open oven door.
• READY displays.
• If door is closed or STOP
changes are discarded and microwave exits programming mode.
2. Press and hold key 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and
programming mode.
3. Press key to be reprogrammed.
• Press two keys if reprogramming a double pad program.
• Power level and cooking time display.
• If power level does not display, microwave is set to full power.
4. Enter cooking time by using the number keys.
5. Press a power level key to change power level if desired.
6. Press START key to save new programming changes to the key.
PROGRAM
• displays.
• If START is not pressed, changes will not be saved.
7. Press STOP/RESET key or close oven door to exit
programming mode.
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory key.
To use stage cooking:
1. Follow steps 1 through 5 above.
6. Press TIME ENTRY key.
• Display briefly shows the key number that is being programmed and
the stage number to the upper right.
• Display changes to cook time and power level for the next stage.
7. Enter cook time and power level as in steps 4 and 5.
• To enter another cooking stage for that key, press
TIME ENTRY key again.
• Up to four different stages can be programmed.
8. Press START key to save new programming changes to the key.
9. Press STOP/RESET key or close oven door to exit programming
mode.
key
is pressed before programming is complete,
PROGRAM
displays. Oven is in
the display will show
when programming keys for single
or double digit cooking sequenses.
To change the oven's default to
allow either single key or double key
programming, see the User Option
section.
press STOP/RESET key once to stop
oven, then again to clear display. If
oven door is open and time shows in
display, close oven door and press
STOP/RESET key to clear display.
10
(Electronic Control)
The display shows
PROGRAM
When set to single key or
double key programming,
PROGRAM

Canceling Mistakes

If oven is not cooking, press
STOP/RESET key to clear
display. If oven is cooking,
QTY X2
Programming
This feature allows a preset
percentage of original cook
time, called a cooking factor, to
be added to a cook sequence.
To change the cooking factor:
1. Open oven door.
2. Press and hold key 1 for
approximately 5 seconds.
3. Press key to be reprogrammed.
4. Press the QTY X2 key.
5. Press a numbered key to
change the cooking factor.
• Cooking factor can be set
from 10% to 100%.
• Default is 80%.
• Key 5 would change the
cooking factor to 50%.
• Key 3 would change the
cooking factor to 30%.
6. Press START key to save
changes.
.