HP Integrity rx2600 Getting Started Manual page 22

Setting Up and Using Your System
1–16
To access the EFI remotely:
1. With the workstation turned off, connect the serial cable provided
with your system (HP part number 5182-4794) or a compatible
cable to Serial Port A on the rear panel of the workstation, and to
your remote device.
2. Configure the terminal emulation software with these settings:
Baud rate: 9600
Bits: 8
Parity: None
Stop Bits: 1 (one)
Flow Control: XON/XOFF
3. Using the terminal emulation software, connect to the
workstation with a direct connection.
NOTE: The default terminal emulation type is VT100+. This setting
can be changed from the EFI
4. Turn on the workstation and follow the steps below to access
the EFI.
HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
Boot Options Maintenance Menu
.