X I .
B A S I C
DIAGNOSTIC FLASH CODES
FLASH CODE
(1)
(2)
(3)
(6)
(7)
(8)
(9)
(10)
36
T R O U B L E S H O O T I N G
CONDITION
Batteries are too low to operate the
scooter or the charger is operating.
Motor disconnected.
Motor wiring fault.
Scooter is operating with the charger
attached.
Throttle potentiometer fault.
Internal controller fault.
Brake fault—your scooter was left in
freewheel mode.
High battery voltage. The batteries have
been overcharged and the scooter won't
run.
www.pridemobility.com
SOLUTION
Charge batteries or unplug the charger power cord
from the electrical outlet.
Check all connections to the motor.
Call your authorized Pride Provider for assistance.
Unplug the charger power cord from the charger power
cord receptacle.
Call your authorized Pride Provider for assistance.
Call your authorized Pride Provider for assistance.
Turn the scooter key to the off position, then push the
manual freewheel lever to the (down) drive position,
and restart your scooter.
Leave the scooter turned on to drain the batteries to a
sufficient level. If the batteries continue to overcharge
call your authorized Pride Provider for assistance.
Legend