Convection Fan Motor - GE Profile J2S968 SERIES Technical Service Manual

Convection Fan Guard
To remove the convection fan guard:
1. Remove the oven door (see Oven Door).
2. Remove 4 hex-head screws that secure the
convection fan guard to the rear wall of the
oven. Remove the convection fan guard.
Convection Element (Dual Fuel)
The convection element has an approximate
resistance value of 20 Ω.
To remove the convection element:
1. Remove the fan guard (see Convection Fan
Guard).
2. Remove the 3 hex-head screws that hold the
element to the rear oven wall.
3. Gently pull the convection element forward to
access the wiring connections.
4. Disconnect the wires and remove the
element.
Note: When reconnecting the element, make
sure the connectors are securely attached to the
element.

Convection Fan Motor

To remove the fan motor the range must be
removed from its installation.
To remove the convection fan motor:
1. Remove the range from its installation (see
Range Removal).
2. Remove the fan guard (see Convection Fan
Guard).
3. Using a 1 / -in. wrench, remove the nut from
2
the convection fan blade by holding the blade
securely and turning the nut clockwise.
Note: Convection fan blade nut has left-handed
threads. Fan blade can be replaced from inside
oven.
4. Remove the fan blade and washer from the
fan motor shaft.
5. Remove the hex-head screws that secure the
service cover to the rear of the range and
remove the cover.
– 34 –