Convection Fan Cover; Convection Fan Motor - GE C2S985 Technical Service Manual

Convection Fan Cover

To remove the convection fan cover:
1. Remove the oven door. (See
2. Remove the 6 Phillips-head screws that attach
the convection fan cover to the back wall of the
oven cavity.
Note: Install the convection fan cover with the arrow
pointing up.
Arrow

Convection Fan Motor

On Café models, check the convection fan motor
resistance from the back of the range. Remove the
rear cover (see
Rear Cover
(see
Lower Oven Gas Valve
1/4-in. hex-head screws (2 on each side) and the
convection fan motor cover from the rear of the
range.
Convection Fan
Motor Cover
Oven Door Removal
) and the gas valve cover
, step 2). Remove the four
On Profi le and GE models, the resistance of the
convection fan can be checked on the ERC. Place
the control panel in the service position. (See
Panel and Electronic Range Control (ERC)
.)
low-speed winding between TB102 (N) and the
brown wire on TB542 (FAN LO) for the approximate
resistance value of 26 Test the high-speed
winding between TB102 (N) and the blue wire on
TB541 (FAN HI) for the approximate resistance value
of 20 Both approximate resistance values are at
room temperature.
To remove the convection fan motor:
1. Remove the convection fan cover. (See
Convection Fan Cover
2. Remove the 4 Phillips-head screws that attach
the convection fan motor to the back wall of the
oven cavity.
3. Disconnect the 3 wires from the convection fan
motor.
Disconnect
– 61 –
Touch
.) Test the
.)
Disconnect
Disconnect
(Continued next page)