Table of Contents
Advertisement
3 • Assembling and Hanging the Fan
Decorative
Sleeve
Metal
Gasket
6
Step 3-1
Step 3-2 - 3-3
Hunter® Fan Company
installation instructions.
Rubber
Gasket
Standard Mounting - 9' ceilings or higher:
• Threading the wires through the adapter, screw the adapter onto
Upper
Canopy
• Loosen the lower setscrew in the adapter. Threading the wires
Pipe
Lower
Canopy
Adaptor
• Slide the lower canopy onto the pipe with the large opening
Rubber
Gasket
• Slide the metal gasket and decorative sleeve onto the pipe (in that
• Slide the upper canopy onto the pipe with the large opening
Low Profile Mounting - 8' - 9' ceilings:
• Threading the wires through the 2.75" pipe, screw the pipe into
• Slide the lower canopy onto the pipe with the large opening
3-1. Screw the hanger bracket onto the top of the pipe at least three
3-2. Center the pin in the rubber bushing.
3-3. Holding the fan by both the motor housing and the pipe, lift the
WARNING: Fan may fall if not assembled as directed in these
the shaft on the top of the fan and securely tighten the upper
setscrew with the included allen wrench.
through the 7" pipe, screw the pipe into the adapter on top of the
fan and securely tighten the upper setscrew.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
facing the fan.
order). Orient the gaskets so that the sleeve will overlap the lip of
each gasket.
facing away from the fan. Then slide the rubber gasket onto the
pipe, oriented so that the lip slides into the sleeve. Continue to
step 3-1.
Note: For Low Profile Mounting, Adapter is not used.
the top of the fan and securely tighten the setscrew.
facing the ceiling, the upper canopy is not used for low profile
mounting.
full turns. Securely tighten the setscrew on the hanger bracket.
fan assembly and hook both sides of the hanger bracket onto the
bushing pin assembly.
43113-01 • 05/04/12
Advertisement
Table of Contents
