Rear Panel - Sony Owner’s Guide Operational Manual

f MENU SEL (selection) /ENTER dial
Used to select or set the items on the subdisplay or the
menu items on the viewfinder (monitor) screen.

Rear panel

a Safety release tab
b Accessory clamp lever
c Lock release knob
d Accessory mount lever
e Recorder/interface box
receptacles
a Safety release tab
b Accessory clamp lever
c Lock release knob
d Accessory mount lever
For mounting/unmounting an SRW-1 HD Portable Digital
Recorder or the interface box to/from the rear of the
camera head.
The mounting/unmounting mechanism is the same as that
on the top (page 13).
For details, see "Chapter 2 Installation and
Preparations".
e Recorder/interface box receptacles
Signals and power are sent/received to/from an SRW-1 HD
Portable Digital Recorder or the supplied interface box
(page 15) mounted on the rear.
The same receptacles are provided on the top to send/
receive signals and power to/from the recorder or the
interface box mounted on the top.
When using a rechargeable battery
Use the receptacles on the rear panel. By attaching the
BKP-L551 to the rear of the interface box, the camera can
be operated on a battery. Note, however, that power will be
fed only to the camera head and viewfinder. Provide
another power source for the recorder.
f RUN indicator and ON/OFF switch
When the switch is set to ON, the indicator will be lit while
the recorder mounted on the camera is in Recording mode.
14
Locations and Functions of Parts
f RUN indicator and ON/OFF switch
OFF ON
g GENLOCK IN connector
h TEST OUT connector
i MONITOR OUT HD SDI connectors 1/2
j REMOTE connector
REMOTE
DC IN connector (see page 11)
k Wrench box
g GENLOCK IN (external sync signal input)
connector (BNC type)
Used for input of an external gen-lock signal (HD 3-level
sync).
h TEST OUT connector (BNC type)
An analog test signal is fed from the connector.
The type of output signal can be set using a menu on the
viewfinder or monitor screen.
i MONITOR OUT HD SDI connectors 1/2 (BNC
type)
An HD SDI signal for monitoring is fed from the
connectors.
The type of output signal can be set using a menu on the
viewfinder or monitor screen.
The same signal is output from connector 1 and 2.
j REMOTE connector (8-pin)
Connect an external control device, such as the RM-B150/
B750 Remote Control Unit.
k Wrench box
A 3-mm wrench for attaching/detaching the handle and a
2.5-mm wrench for attaching/detaching the viewfinder
shoe are accommodated.