Sony Owner’s Guide Operational Manual page 12

The necessary settings are made using the NETWORK
menu displayed on the viewfinder or monitor screen.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
ATTENTION
Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une tension
excessive à ce port. Suivez les instructions pour ce port.
ACHTUNG
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Right panel
a Assignable buttons 1, 2, 3
b LOCK switch
c RUN button and indicator
d 4/AUTO BLK BAL switch
a Assignable buttons 1, 2, 3
You can assign various functions to these buttons, using
the subdisplay on the left panel or on the assistant panel or
the menu displayed on the viewfinder or monitor screen.
The ND filter selection function is assigned to button 1 and
the CC filter selection function to button 2 at the factory.
(No function is assigned to button 3.)
For details, see "3-2-10 Allocation of Functions to the
Assignable Buttons and Switch" (page 35) and "3-7
Detailed Settings of the Switch Functions" (page 48).
b LOCK switch
To disable operations on the panel.
12
Locations and Functions of Parts
Buchse haben könnte. Folgen Sie den Anweisungen für
diese Buchse.
i DC OUT 12V (DC 12V power output) connector
DC 12V power can be fed to an accessory.
j DC OUT 24V (DC 24V power output) connector
DC 24 V power can be fed to an accessory.
k Measure hook/focus reference mark
Use as reference for focusing. The same reference mark is
also provided at the right of the riser plate (page 13).
For actual measurement of the distance from a subject, you
can fix the end of a tape measure to the hook.
e Safety release tab
f Accessory clamp lever
g Lock release knob
h Accessory mount lever
1 2 3
Riser plate
You can make a setting to allow the RUN button to be
activated even when the LOCK switch is set to ON on the
<SUBDISPLAY 2> page on the USER (OPERATION)
menu.
c RUN button and indicator
To start/stop recording on the SRW-1 HD Portable Digital
Recorder docked on the camera. The indicator is lit while
the recorder is in Recording mode.
The indicator flashes as a warning in some cases.
For details on warning indication, see "Warning/Error
Messages" (page 108).
Display/menu operation block
(page 13)
i Memory stick section
j Focus reference mark
k Tripod receptacles (bottom)