Chevrolet 2003 Silverado Owner's Manual page 275

Problem
In auxiliary mode, the
picture moves or scrolls.
The language in the
audio or on the screen is
wrong.
The remote control does
not work.
Recommended Action
Check the signal coming
from the auxiliary device
and make sure that the
connection and the signal
is good.
Change the Video
Format to PAL or NTSC.
See "Stereo RCA Jacks"
previously for how to
change the video format.
Press the Menu button
on the DVD player or on
the remote control and
change the audio or
language selection on the
DVD menu.
Point the remote control
directly at the infrared
window below the video
screen while using.
Check that the batteries
are not dead or put in
wrong.
The parental control
button might have been
pressed. (The power
indicator light will flash.)
Problem
After stopping the player, I
push Play but sometimes
the DVD starts where I
left off and sometimes at
the beginning.
The auxiliary source is
running but there is no
picture or sound.
My disc is stuck in the
player. The Load/Eject
button does not work.
Recommended Action
If the stop button was
pressed one time, the
DVD player will resume
playing where the DVD
was stopped. If the stop
button was pressed two
times the DVD player will
begin to play from the
beginning of the DVD.
Press the SRCE button to
change from the DVD
player mode to the
auxiliary source mode.
Check to make sure that
the auxiliary source is
connected to the inputs
properly.
Press the Load/Eject
button on the DVD
player.
Turn the power off, then
on again, then press the
Load/Eject button on the
DVD player.
Do not attempt to forcibly
remove the disc from the
DVD player. This could
permanently damage the
DVD player.
3-119