Programming Selectable Options - Code Alarm Vehicle Security System Owner's Manual

System Maintenance (cont.)

Programming Selectable Options

NOTE: Transmitters supplied with system are preprogrammed. See page 8 for
instructions on programming additional transmitters.
1. Open driver's door.
2. Turn vehicle ignition ON.
Press and hold programming button in. After 10-15 seconds siren will sound 3
3.
times to indicate transmitter learn mode.
Release, press and release programming button. Siren will sound 4 times.
4.
5. Using a programmed transmitter, press LOCK button to advance to the next
option. Siren will sound to indicate option number.
6. Press DISARM to turn selected option ON or OFF. Status Indicator will light if an
option is ON.
7. Turn Ignition OFF to end option programming.
Button 1
Press to
Advance to
Next Option
Press Button 3
to Reset all Options
to Factory Settings
Exit the Selectable Options Mode by turning the vehicle ignition off.
Option 1 Option 2
ON OFF ON OFF
8
DISARM
ARM
TRUNK
Turn Option
ON or OFF
P ANIC
Installer: Record Selectable Options Settings Here:
Option 3 Option 4
ON OFF ON OFF
Button 2
Press to
Option 5 Option 6
ON OFF ON OFF
Status Indicator
Displays Option Status
(ON or OFF)
Number of Siren Chirps
Indicate Option Number
Option 7 Option 8
ON OFF ON OFF