Recording Operations; Dubbing Tapes From The Cd Deck; If The Tape Is In Stop Mode; If The Tape Is In Record Pause Mode - Tascam CC-222MKII Owner's Manual

Recording operations

NOTE
CAUTION
Recording pre-recorded tapes, records, or
lished or broadcast material may infringe copyright laws.
Check before recording.
1 With the power on, set the
switch
.
If you want to make a bi-directional record-
ing, set the
REV MODE
p position.
Set to the u (single side) position if record-
ing is to be made on a single side of the tape.
2 Load a recordable cassette. Check that the
safety tabs on the spine of the cassette are in
place. If they have been broken off, block the
holes with adhesive tape.
3
Press the
INPUT 2 SEL
source (either
LINE2
When is selected, the built-in CD
DISC
player's output is selected as a source.
When is selected, the external signal
LINE2
from the jacks is selected as a source.
LINE 2

Dubbing tapes from the CD deck

To record from the internal CD deck:
1
Prepare for recording as described above
(load a tape, set the
2
Load the source CD disc (press
, put the disc in the tray, recorded
CLOSE
side downwards, and close the tray).
3
Use the MENU key to set the dubbing volume
to to bypass the input level control
THRU
(see "Bypassing the INPUT level for dub-
bing" on page 18).
NOTE
If you want to record the tracks on the tape in a differ-
ent order from those on the disc, use the programmed
playback mode to rearrange the tracks ("Programmed
order playback" on page 22). Leave the disc in stop
mode when you have finished programming the order.
4
Press the DUB 2 key.
3 – Cassette operations—Recording operations
other pub-
REV MODE
switch to the j or
key to select the
or ).
DISC
, etc.).
REV MODE
OPEN/
4 Set the Dolby NR system on or off.
5
Press the RECORD
record pause mode (the display indicators
light).
6 Play back the source, and adjust the record-
ing level with the
INPUT
the loudest sound to be recorded just makes
the meters briefly reach around the "0 dB"
point for normal or high-position tapes
(recording is not possible with metal tapes).
7
Press either the PAUSE
recording.
To stop recording temporarily, press the
key. To restart the tape, press either
PAUSE
the key or either of the
PAUSE
When the unit is in record pause mode, if the
PLAY key whose indicator is lit is pressed
recording will restart. If the
indicator is unlit is pressed, the recording
direction will reverse, and the
be pressed again to restart recording.
To stop recording, press the

If the tape is in stop mode

stop mode, the tape rewinds to the beginning of the
current side.
At the start of the tape, recording starts, but the CD
does not start playback for eight seconds (this is to
allow for the leader tape at the start of a cassette).
The indicator flashes.
DUB
The CD starts playback after the eight seconds at the
start of the cassette. The
DUB

If the tape is in record pause mode

tape is in record pause mode, recording starts imme-
diately, and the CD starts playback immediately. The
indicator lights.
DUB
If you want to adjust the input volume, set
the menu to
DUB>VOL
(tape) control to adjust the level of sig-
INPUT
nals fed to the tape from the CD player.
TASCAM CC-222MKII Owner's Manual
key. The deck enters
level control so that
or PLAY key to start
keys.
PLAY
key whose
PLAY
key must
PLAY
key.
STOP
If the tape is in
indicator lights steadily.
If the
and use the left
ON
17