Volvo XC 70 Owner's Manual page 231

Heading combinations
Average fuel consumption Trip odometer T1 + mileage
Current fuel consumption Trip odometer T2 + mileage
Current fuel consumption
- No trip computer informa-
Scroll among the trip computer information
headings at any time by turning the thumb
wheel until the desired heading is displayed.
Supplementary information
Average fuel consumption
Fuel consumption since the last time this
function was reset.
Average speed
The vehicle's average speed since the last
time this function was reset.
Current fuel consumption
Current fuel consumption is calculated
approximately once a second. When the vehi-
cle is moving at low speed, fuel consumption
is displayed per unit of time. At higher
speeds, it is displayed in terms of distance.
Average speed
Distance to empty
Mileage mph<>kmh
tion displayed
Miles or kilometers can be displayed, see the
heading "Changing units" on page 230
Distance to empty
This function shows the approximate dis-
tance that can be driven on the fuel remaining
Distance to empty
in the tank. When
"----", there is very little useable fuel remain-
ing in that tank; refuel as soon as possible.
The calculation is based on average fuel con-
sumption during the last 20 miles (30 km) of
driving and the amount of fuel remaining in
the tank (the accuracy of this figure may vary
if your driving style changes). An economical
driving style will generally increase this dis-
tance.
See page 284 for information about driving
economically.
05 Comfort and driving pleasure
Description
•
Press and hold RESET to reset trip odometer T1.
•
Press and hold RESET to reset trip odometer T2.
Change between mph<>kmh – see "Digital speed display" on
page 229.
- No information will be displayed. This also indicates the begin-
ning/end of the list of information headings.
Digital speed display*
Speed is expressed in the unit not used by
the instrument panel's speedometer e.g., if
the normal speedometer is in mph, the trip
computer will display in the speed in km/h
and vice versa.
shows
Resetting an analog instrument panel
Trip odometer(s) and average speed
1. Display trip odometer T1 or T1, or Aver-
2. Press and hold RESET until selected
Each trip computer heading must be reset
individually.
*
Option/accessory, for more information, see Introduction.
Trip computer
age speed.
function is reset.
05
}}
229