Volvo XC 70 Owner's Manual page 122

03 Your driving environment
HomeLink ® Wireless Control System*
2. Simultaneously press and hold both the
chosen HomeLink and hand-held trans-
mitter buttons until the HomeLink indica-
tor light changes from a slow to a rapidly
blinking light. Now you may release both
the HomeLink and hand-held transmitter
buttons.
03
NOTE
Some devices may require you to replace
this Programming Step 2 with procedures
noted in the "Gate Operator / Canadian
Programming" section. If the HomeLink
indicator light does not change to a rapidly
blinking light after performing these steps,
contact HomeLink at www.homelink.com
or by phoning the hotline at
1–800–355–3515.
*
120
Option/accessory, for more information, see Introduction.
3. Firmly press, hold for five seconds and
release the programmed HomeLink but-
ton up to two separate times to activate
the door. If the door does not activate,
press and hold the just-trained HomeLink
button and observe the indicator light.
•
If the indicator light stays on con-
stantly, programming is complete
and your device should activate when
the HomeLink button is pressed and
released.
•
If the indicator light blinks rapidly for
two seconds and then turns to a
constant light continue with "Pro-
gramming" steps 4-6 to complete the
programming of a rolling code equip-
ped device (most commonly a garage
door opener).
4. At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit.
5. Firmly press and release the "learn" or
"smart" button. (The name and color of
the button may vary by manufacturer.)
There are 30 seconds to initiate step 6.
6. Return to the vehicle and firmly press,
hold for two seconds and release the pro-
grammed HomeLink button. Repeat the
"press/hold/release" sequence a second
time, and, depending on the brand of the
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
HomeLink should now activate your rolling
code equipped device.
Gate Operator/Canadian Programming
Canadian radio-frequency laws require trans-
mitter signals to "time-out" (or quit) after sev-
eral seconds of transmission – which may not
be long enough for HomeLink to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators are
designed to "time-out" in the same manner.
If you live in Canada or you are having diffi-
culties programming a gate operator or
garage door opener by using the "Program-
ming" procedures, replace "Programming
HomeLink" step 2 with the following:
•
Continue to press and hold the HomeLink
button while you press and release -
every two seconds ("cycle") your hand-
held transmitter until the HomeLink indi-
cator light changes from a slow to a rap-
idly blinking light. Now you may release