Cruise Control; Setting A Speed; Adjusting The Set Speed; Steering Wheel-Mounted Controls And Display - Volvo XC 70 Owner's Manual

04 Driver support

Cruise control

Operation
04

Steering wheel-mounted controls and display

Standby mode
Resume set speed
Deactivating
Activate/set speed
Selected speed (gray symbol indicates
standby mode)
Cruise control active: white symbol (gray
symbol indicates standby mode)
156
Engaging the cruise control function
Before a speed can be set, the cruise control
system must be engaged (put in standby
mode).
– Press the CRUISE button (1).
> The symbol
illuminates and the text
(---) mph
(5) indicates that cruise con-
trol is in standby mode.
NOTE
Putting cruise control in standby mode
does not set a cruising speed.

Setting a speed

Use the or buttons set the vehicle's
current speed. The set speed is shown in the
display.
NOTE
Cruise control cannot be engaged at
speeds below 20 mph (30 km/h).

Adjusting the set speed

After a speed has been set, it can be
increased or decreased by using the
buttons.
1. Press
or briefly and release the
button to increase or decrease vehicle
speed by approximately 5 mph (8 km/h).
> This will become the set speed when
the button is released.
2. To adjust the speed in increments of
1 mph (approx. 2 km/h), press and hold
down or until the vehicle reaches
the desired speed.
NOTE
•
A temporary increase in speed by
pressing the accelerator pedal, for less
than 1 minute (e.g. when passing
another car), does not affect the cur-
rent cruise control setting. The vehicle
will automatically return to the previ-
ously set speed when the accelerator
pedal is released.
•
If one of the cruise control buttons is
kept depressed for more than approx.
1 minute cruise control is disengaged.
The engine must then be switched off
in order to reset cruise control.
or