Product Identification; Unpacking; Assembly - Desa RC40 Owner's Manual

PRODUCT IDENTIFICATION

Hot Air
Outlet
Lower
Shell
Fuel
Tank
Side Cover
Ignition Control

Assembly

(assembly on inside
of side cover)
Figure 1 - 40 Model
Hot Air
Outlet
Lower
Shell
Fuel Tank
Side Cover
Ignition Control
Assembly
(assembly on inside
of side cover)
Figure 2 - 55T/70T Models
Hot Air
Outlet
Lower
Shell
Fuel Cap
Side Cover
Ignition Control
Assembly (assembly on
inside of side cover)
Figure 3 - 115T/165T Models
105536
Nose Cone Guard
Upper Shell
Handle
Fan Guard
Power Cord
Nose Cone Guard
Thermostat
Knob
Upper Shell
Handle
Fan Guard
Air Filter
End Cover
Power Cord
Thermostat
Upper Shell
Knob
Fan Guard
Power Cord
For more information, visit www.desatech.com
For more information, visit www.desatech.com

UNPACKING

1. Remove all protective packaging that has been applied to heater
for shipment
2. Remove heater from carton.
3. Check heater for any shipping damage. If damage is found,
promptly inform dealer where heater was purchased.
ASSEMBLY
Air Filter
End
(FOR 40, 55T, AND 70T MODELS ONLY)
Cover
Fuel
These models are furnished with a nose cone guard. Nose cone
Cap
guard and mounting screws are found in the shipping carton.
Tools Needed
• 5/16" Nut Driver or Wrench
1. Place nose cone guard on top of upper shell flange. Make sure
nose cone guard is on hot air outlet end of heater.
2. Insert screws through nose cone guard and upper shell flange.
3. Tighten screws firmly.
Hot Air
Outlet
Upper
Shell
Flange
Fuel
Cap
Figure 4 - Nose Cone Guard Assembly, 40/55T/70T Models Only
Fuel
Tank
PRODUCT IDENTIFICATION
UNPACKING
ASSEMBLY
Nose Cone
Guard
Screw
3 3