IBM eServer BladeCenter JS20 Installation And User Manual page 93

Checkpoint code Description
E218 Copy the set of flash RAM to
memory.
E219 Save the dual in-line memory module
(DIMM) serial presence detects
(SPDs) and the processor status and
presence.
E21A Running code from memory.
E21B Load PFW into memory.
E21C Run HyperTransport (HT)
initialization.
E21D Run PCI initialization.
E21E Run I/O advanced programmable
interrupt controller (APIC)
initialization.
E21F Building the partition fundamental
data structure (PFDS).
E2B0 Reserved
E2B1 Reserved
E440 Validate NVRAM and initialize
partitions as needed.
Suggested action
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
No action is required.
No action is required.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Chapter 8. Solving problems
77