About; Resetting To Factory Default Settings - Axis 231D User Manual

Plain Config - this function is for the advanced user. All parameters can be set and
modified from this page, help is available from the standard help pages.

About

Third Party Software Licenses - click View licenses for a list of the licensed software
used in the AXIS 231D/232D Network Dome Camera.

Resetting to Factory Default Settings

To reset the AXIS 231D/232D to the original default settings, go to the System Options |
Maintenance web page (described in Maintenance, on page 29) or use the control button
on the AXIS 231D/232D as described below:
Using the Control Button
Follow the instructions below to reset the AXIS 231D/232D to factory default settings
using the Control Button.
1. Switch off the AXIS
231D/232D by disconnecting
the power.
2. Press and hold the Control
button while you reconnect the
power.
3. Keep the Control button
pressed until the Power
Indicator flashes amber (this
may take up to 15 seconds).
4. Release the Control button.
5. When the Power Indicator changes to green (may take up to 1 minute), the process is
complete and the AXIS 231D/232D has been reset.
AXIS 231D/232D - System Options
31
Network Indicator
Power Indicator
Control button