Selected Voice Features - Lucent Technologies 6408+ User Manual

Selected Voice Features

Abbreviated Dialing/Automatic Dialing (AD)
The Abbreviated Dialing (AD) feature allows you to store selected telephone
numbers for quick and easy dialing. Each number can be a complete or
partial telephone number, an extension number, or a trunk or feature access
code. Abbreviated Dialing offers four possible types of lists — Personal,
Group, System, and Enhanced, and you can have a total of three lists. (Of
these three lists, you can have only one System List and one Enhanced List.)
You program numbers on a Personal List; numbers on Group Lists are
programmable by the controller of the list; System Lists and Enhanced Lists
are programmable only by the system manager.
You can also program a number on an AD button that is not stored on an AD
list. This Automatic Dialing number can be up to 16 digits and characters.
For all 6408+ telephones, and all 6408D+, 6416D+ and 6416D+M, and
6424D+ and 6424D+M telephones connected to DEFINITY switches 6.2
and prior releases, or when using the Program feature access code
To program/reprogram an AD button (administered as a feature button)
Note: The system manager must first program a call appearance/
feature button as an AD button before you can program a
number on it.
Note: There is a 10-second time limit between your entering the
Program mode and entering the first digit of an AD button, and
then a 10-second time limit between each digit. If you hear
intercept tone while you are programming the button, you have
exceeded the time limit and you must begin again.
1. Locate the Program button on your telephone. There are three
possibilities.
a. If you are using a telephone with a display, press the Menu button
and, if necessary, the Next or Prev button until Prog appears on the
display screen.
b. If you telephone does not have a display or if Prog is not available on
your display, press
c. Ask your system manager for the AD Program feature access code.
2. Pick up the handset or press
3. Press the Prog button (or dial the feature access code).
4. Press the AD button to be programmed.
5. Dial an outside number, extension, or feature access code you want to
store (as you would normally dial it).
6. Press .
#
7. Repeat Steps 4 through 6 (within 10 seconds) to program additional
buttons.
8. Hang up or press
Program
[confirmation tone]
to end programming.
Spkr
10
administered as a feature button.
[dial tone]
.
Spkr