Turning On The Antenna - KVH Industries DIRECTV User Manual

2-1

Turning On the Antenna

To quickly start watching satellite TV using the
TracVision system, follow the simple steps below.
1. Apply power to the mobile receiver/controller.
The Receiver status light should turn green.
2. Turn on your TV and select the satellite input (not
the VCR input).
3. Wait 30-60 seconds for the antenna to acquire the
satellite signal. The TV will show the following:
If your satellite dish is ready for DIRECTV
service, please wait until your
Advanced Program Guide
Message 1
If your satellite dish is ready for DIRECTV
service, please wait until your
Advanced Program Guide
Message 2
54-0376
®
™ is prepared.
Installation
Signal not available...
®
™ is prepared.
Installation
Acquiring guide data...
4. If Message 1 does not
appear after 30 seconds,
press the remote control's
SAT button. Then press
the remote's PWR button.
The receiver beeps twice,
the Antenna status light begins to flash green,
and the Voltage status light should be lit green.
Status Lights
If the receiver's Voltage status
light is off, press the power
switch on the front of the
receiver to turn on the
receiver.
Getting Started
PWR
DVD VCR AUX TV SAT
GUIDE
MENU FAV
TURBO
For details about the status
lights, see Section 10-4,
"System Status Lights" on
page 10.10.
Power Switch
2.3