Information - Culligan 9" Owner's Manual

Information

01021076
34
The following information can be displayed at the control valve or remote display. These settings are read-
only. Press or to scroll through the settings. Press
Screen Display
SOFTENING
JAN-01-13 12:01P
>1)INFORMATION
2)MANUAL MODE
SALT TANK LEVEL
OK
REMAIN CAPACITY
100%
REMAIN CAPACITY
740 GAL
CURRENT FLOWRATE
0.0 GPM
TODAY's USAGE
0 GAL
AVERAGE DAILY
300 GAL
Range
From the HOME screen, press
1.
N/A
2. The screen displays the main menu. Press
1–6
1)INFORMATION.
3. If a Smart Brine Tank is installed, this screen displays the
salt level. The status is OK unless the SBT probe detects
an overfilled brine tank or low salt level. If the screen
OK,
displays LOW a subsequent screen displays APPROX
Low
DAYS OF SALT REMAINING. Press
next information screen.
4. The screen displays the softening capacity remaining,
displayed as a percentage of the total capacity. During
manually initiated regeneration, assume 0 percent re-
0–100
maining capacity. Press
tion screen.
5. The screen displays the softening capacity remaining,
0–no
measured in gallons (liters). Press
limit
information screen.
6. The screen displays the current flow rate, measured in
0–no
gallons (liters) per minute. Press
limit
formation screen.
7. The screen displays today's water usage, measured in
0–no
gallons (liters). Press
limit
screen.
8. The screen displays average water usage for this config-
0–no
limit
uration. Press
to view the previous setting.
Setting Description
to view the main menu.
to select the next informa-
to see the next
to see the next in-
to see the next information
to see the next information screen.
to select
to select the