Lcd Description - Eaton 5P 650i Installation And User Manual

2.5 LCD description

Load/equipment status
As default, or after 5 minutes of inactivity, the LCD displays the screen saver.
The backlight LCD automatically dims after 10 minutes of inactivity. Press any button to restore the screen.
The following table describes the status information provided by the UPS
Note. If other indicator appears, see troubleshooting on page 18 for additional information.
Operation status
Standby mode
Normal mode
In AVR mode
No beep
On Battery
Battery LED is on
1 beep every 10 seconds
End of backup time
1 beep every 3 seconds
620-00082-02-i (en)
Operation status
Normal mode
100%
720W
800VA
Efficiency: ~98%
Efficiency and load group information
Possible cause
The UPS is OFF, waiting for start-up
command from user
The UPS is operating normally.
The UPS is operating normally but
the utility voltage is outside normal
mode thresholds.
A utility failure has occurred and
the UPS is in Battery mode.
The UPS is in battery mode and
the battery is running low.
2. Presentation
100%
10min
Battery status
Action
Equipment is not powered until
button is not pressed.
The UPS is powering and protecting
the equipment.
The UPS is powering the
equipment through a Automatic
Voltage Regulation device.
The equipment is still normally
protected.
The UPS is powering the equipment
with the battery power. Prepare
your equipment for shutdown.
This warning is approximate, and
the actual time to shutdown may
vary significantly.
Depending on the UPS Load, the
"Battery Low" warning may occur
before the battery reaches 20 %
capacity.
Page 9