Display Functions; User Settings - Eaton 5P 650i Installation And User Manual

2. Presentation

2.6 Display functions

Press the Enter (
through the menu structure. Press the Enter (
or return to the previous menu.
Menu map for Display Functions.
Main menu
Measurements
Control
Settings
Fault log
Identification

2.7 User settings

The following table displays the options that can be changed by the user.
Local settings
In/Out settings
Page 10
) button to activate the menu options. Use the two middle buttons (
Submenu
Load Segments
Start battery test
Reset fault state
Restore factory settings Returns all settings to original values (UPS restart required)
Reset power usage
Local settings
Input / output settings
ON / OFF settings
Battery settings
Description Available settings
Language [English] [Français] [Deutsch]
[Italiano] [Português] [Español]
[Русский]
Menus, status, notices and alarms,
UPS fault, Event Log data and
settings are in all supported
languages.
LCD settings Modify LCD screen brightness and
contrast to adapt to room light
conditions.
Audible alarm [Enabled] [Disabled on battery]
[Always disabled]
Enable or disable the buzzer if an
alarm occurs.
Output voltage [200 V] [208 V] [220 V] [230 V]
[240 V]
Input thresholds [Normal mode] [Extended mode]
Extended mode reduces lower
input voltage to 150 V before UPS
transfers to battery.
This can be used if the load can
withstand low voltage supply.
Sensitivity [High] [Low]
High: for sensitive equipment,
UPS will easily transfer to battery
when utility conditions are
becoming bad.
Low: for equipment that can
withstand bad utility conditions,
in that case, the UPS will not
transfer to battery.
Load segments - [No Delay] [1 s] [2 s]...[65354 s]
Auto start delay The connected load is powered
after the specified delay.
) button to select an option. Press the
Display information or Menu function
Load W VA / Load A pf / Output V Hz / Input V Hz /
Battery V min / Efficiency / Power usage
Group 1: ON / OFF
Group 2: ON / OFF
These commands overrule user settings for load segments.
Starts a manual battery test
Clears active faults
Clears power usage measurements
Sets product general parameters
Sets Input and output parameters
Sets ON / OFF conditions
Sets battery configuration
Displays event log or alarms
UPS Type / Part Number / Serial Number / Firmware release /
Com card address
and ) to scroll
button to cancel
Default settings
English
User selectable when UPS is
powered for the first time.
Enabled
User selectable when UPS
is powered for the first time.
Normal mode
High
Group 1: 3 s
Group 2: 6 s
620-00082-02-i (en)