Epson EB-X24 User Manual page 93

Problem Solving
Indicators
Power sup‐ Status
ply
Off Blue - Flash‐ Orange - Lit
ing
Off Blue - Flash‐
ing
Off Blue - Flash‐ Orange - Lit
ing
Blue - Flash‐ State de‐
ing pendant in‐ pendant in‐
dication
Cause
Lamp Tempera‐
ture
Lamp Error
Lamp Failure
Off
Lamp Cover Open
Auto Iris Error
Orange - Orange -
Flashing Flashing
Power Err.
Orange - Lit
High Temp Warn‐
ing
State de‐ Orange -
Flashing
dication
Check the following two points.
• Take out the lamp and check if it is cracked.
s "Replacing the Lamp" p.108
• Clean the air filter.
s "Cleaning the Air Filter" p.106
If the lamp is not cracked: Reinstall the lamp and plug in the power cord.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson
Projector Contact List. (Images cannot be projected until the lamp is replaced.)
Epson Projector Contact List
s
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.78
Check that the lamp and the lamp cover are securely installed.
The lamp does not turn on if the lamp and the lamp cover are not installed correctly.
s "Replacing the Lamp" p.108
Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
(This is not an abnormality. However, if the temperature rises too high again, projection stops
automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.106, "Replacing the Air Filter"
Remedy or Status
p.111
93