Advertisement
Z = 6,5 ± 1,5 mm (steel rim)
Clearance Z:
Z = 5 - 0/+ 1 mm (alu rim)
referred to the centre of the wheel sensor.
Offset Y:
The centre of the sensor must be located over the
entire circumference of the wheel over the magnetic
strip.
Set angle:
The edges of the wheel sensor must be set at a
distance conforming to Z.
Turning angle:
The turning angle must not exceed 10°.
Length of the
metal holder:
The free-standing length must be kept as short as
possible (max. 90 mm).
If the free-standing length is greater than 90 mm,
then the metal holder must be reinforced.
Rotation angle T:
The rotation angle must not exceed 20°.
Special case: T = 90°, do not mount the metal
holder facing in the direction of the magnetic strip.
Installation tolerances for the wheel sensors Fig. 5
centre of the sensor
Y
Y
≤ 10˚
≤ 90 mm
T
- 28 -
Z
Special case
Metal holder will affect
the magnetic field
Advertisement
