Adjusting Trim Angle - Yamaha F75 Owner's Manual

Operation
1. Trim operating angle
EMU27881

Adjusting trim angle

Power trim and tilt models
EWM00750
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instability
or control problems. Improper trim an-
gle can cause loss of control.
Use the power tilt switch located on the
G
bottom engine cowling (if equipped)
only when the boat is at a complete stop
with the engine off.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
35
1
ZMU04258
1. Power trim and tilt switch
1. Power trim and tilt switch
UP
DN
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
Make test runs with the trim set to different an-
gles to find the position that works best for
your boat and operating conditions.
1
ZMU04231