Checking Power Trim And Tilt / Power Tilt System; Checking Propeller - Yamaha F75 Owner's Manual

NOTE:
If any leaks are found, consult your Yamaha
dealer.
EMU29162
Checking power trim and tilt / power
tilt system
EWM00430
WARNING
Never get under the lower unit while it is
G
tilted, even when the tilt support lever is
locked. Severe injury could occur if the
outboard motor accidentally falls.
Make sure no one is under the outboard
G
motor before performing this test.
1. Check the power trim and tilt unit / the
power tilt unit for any sign of oil leaks.
1. Tilt rod
2. Operate each of the power trim and tilt
switches / the power tilt switches on the
remote control and engine bottom cowl-
ing (if equipped) to check that all switches
work.
3. Tilt the outboard motor up and check that
the trim and tilt rod / the tilt rod is pushed
out completely.
4. Check that the trim and tilt rod / the tilt rod
is free of corrosion or other flaws.
5. Tilt the outboard motor down. Check that
the trim and tilt rod / the tilt rod operates
smoothly.
NOTE:
Consult your Yamaha dealer if any operation
is abnormal.
EMU29171

Checking propeller

EWM00321
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller.
Before inspecting, removing, or install-
G
ing the propeller, remove the spark plug
caps from the spark plugs. Also, place
the shift control in neutral, turn the main
switch to "
and remove the lanyard from the engine
stop switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propel-
G
ler when loosening or tightening the
propeller nut. Put a wood block between
1
the anti-cavitation plate and the propel-
ler to prevent the propeller from turning.
ZMU04244
Maintenance
WARNING
" (off) and remove the key,
ZMU04262
54