Alpine CDE-100 Owner's Manual page 14

CD ERR1
I
• The disc is dirty or upside down.
- Press the
~
button and eject the CD.
If not ejecting, consult your Alpine dealer.
CD ERR2
• The disc has scratches.
- Press the ~ button and eject the CD.
If not ejecting. consult your Alpine dealer.
CD ERR3
• Mechanism error.
- Consult your Alpine dealer.
CD ERR4
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling ratelbit rate that is supported by the unit
CD ERRS
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
USB ERR1
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
USB ERR2
• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Disconnect the USB memory device and turn off the power and
turn on Connect another USB memory.
USB ERR3
• Communication error.
- Turn the ignition key off, and then set to ON again.
USB ERR4
I
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling ratelbit rate that is supported by the unit.
USB ERRS
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.