Power Source - Whistler HIGH SURGE POWER INVERTERS Owner's Manual

• Check frequently to ensure that the input and
output connections are secure. Loose connections
may damage the inverter, the power source, or
may generate excessive heat.
• The following precautions apply to the 3000 watt
models only.
To generate the maximum output, the 3000 watt model
should be connected to a power supply which has the
capacity to produce up to 300 amps. The loads should
be distributed between the two receptacles to ensure
that each outlet is producing no more than its maximum
1500 watt output.
If more than one piece of equipment or appliance is
to be operated at the same time, first turn on the
inverter and then turn on each piece of equipment or
appliance separately to enable the inverter to produce
the required start up loads.
Important Information on Battery Chargers
Using your inverter to recharge units designed to charge such
portable equipment as power tools, flashlights, video cameras
and laptop computers may cause damage to the inverter
or the charging unit. Check with the appliance manufacturer
for compatibility with sine wave inverters if you're unsure.
Although we advise against it, if you attempt to recharge a
charging unit, monitor the temperature of the charging unit
for approximately 10 minutes. If the charging unit becomes
unusually warm, disconnect it from the inverter immediately.
OPERATION
18