Mld Snooping-Proxy; Mld Snooping-Proxy Vlan - ZyXEL Communications GS2210 Series User Manual

23.5.1 MLD Snooping-proxy

Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See
multicasting.
Figure 128 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following tabel describes the fields in the above screen.
Table 75 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL
MLD Snooping-proxy
Active
802.1p Priority
Apply
Cancel

23.5.2 MLD Snooping-proxy VLAN

Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD
Snooping-proxy screen to display the screen as shown. See
information on multicasting.
Chapter 23 Multicast
Section 23.1 on page 168
DESCRIPTION
Use these settings to configure MLD snooping-proxy.
Select Active to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
Select a priority level (0-7) to which the Switch changes the priority in outgoing
MLD messages.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
179
for more information on
Section 23.1 on page 168 for more