Transporting - Exmark Laser Z XP Operator's Manual

IMPORTANT: DO NOT crank the engine continuously for more then
ten (10) seconds at a time. If the engine does not start, allow a 60
second cool-down period between starting attempts. Failure to follow
these guidelines can burn out the starter motor.
d) After starting a cold engine, gradually return choke to the "OFF" position as
the engine warms up.
For 27 HP Daihatsu Diesel Units:
b) On a warm engine, place the throttle in the "SLOW" position.
On a cold engine (below 14° F (-10° C)), place the throttle in the "FAST"
position.
Note: Do not use fuel left over from summer.
c) Turn the ignition switch to the "ON" position. The glow plug light will turn
on. Wait for the glow plug light to turn off and turn the ignition switch to the
"START" position. Release the switch as soon as the engine starts.
IMPORTANT: DO NOT crank the engine continuously for more then
ten (10) seconds at a time. If the engine does not start, allow a 60
second cool-down period between starting attempts. Failure to follow
these guidelines can burn out the starter motor.
c) Move the throttle to the "SLOW" (if in "FAST") and let the engine warm up a
few minutes before moving the throttle to the "FAST" position.
4.3.3 Engaging PTO: The PTO push-pull switch engages the cutting blades. Be sure
that all persons are clear of the mower deck and discharge area before
engaging PTO.
IMPORTANT: Operator must be in seat before the PTO can be engaged.
Set throttle to "midway" position. Pull outward on the switch to the "ROTATE"
position. Accelerate to full throttle to begin mowing.
4.3.4 Stopping PTO: Set throttle to the "idle" position. Push in on the switch to the
"STOP" position stopping the cutting blades.
4.3.5 Stopping Engine:
a) Bring unit to a full stop. Disengage the PTO, move motion control
levers out to the neutral lock position and set parking brake.
b) Before stopping the engine, move the throttle control to the "SLOW"
position. Keep on running at idle for a short time, (approximately one
minute) then stop the engine.
NOTE: For 31 HP Daihatsu Gas Units - Do not move the choke to the "ON"
position to stop the engine. Backfire or engine damage may occur.
c) Rotate ignition switch to "OFF" position. Remove the key to prevent
children or other unauthorized persons from starting engine.
d) Close fuel shut-off valve when machine will not be used for a few days,
when transporting, and when the unit is parked inside a building.

4.4 TRANSPORTING

4.4.1 Transporting a Unit: Use a heavy-duty trailer or truck to transport the machine. Lock
brake and block wheels. Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes. Be sure that the trailer or truck has all necessary
lighting and marking as required by law. Secure a trailer with a safety chain.
- 21 -