Periodic Maintenance - Exmark Viking Hydro Operator's Manual

Hide thumbs Also See for Viking Hydro:
Table of Contents

Advertisement

5.1 PERIODIC MAINTENANCE

5.1.1
Check engine oil level.
Service Interval: See Engine Owner's Manual
a)
Make sure engine is on a level surface. Stop engine and wait for all
moving parts to stop.
b)
Check with engine cool.
c)
Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the
dipstick (DO NOT screw into place). Remove dipstick and check oil level.
d)
If the oil level is low, add oil as specified in the Engine Owner's Manual to
bring the oil level up to the "Full" mark on the dipstick.
DO NOT OVERFILL.
IMPORTANT: DO NOT operate the engine with oil level below the "LOW"
(or "ADD") mark or over the "FULL" mark.
5.1.2
Clean engine air cooling system.
Service Interval: See Engine Owner's Manual
a)
Stop engine and wait for all moving parts to stop. Remove key or spark
plug wire(s).
b)
Clean all debris from engine air intake screen and from around engine
shrouding.
5.1.3
Clean grass build-up under deck and check mower blades.
Service Interval: Daily
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
a)
Disengage PTO.
b)
Stop engine and wait for all moving parts to stop. Remove key or spark
plug wire(s).
c)
Raise deck and block up using proper safety precautions.
d)
Clean out any grass build-up from underside of deck and in deck
discharge chute.
e)
Inspect blades and sharpen or replace as required.
f)
If blade removal is necessary, be careful for the sharp cutting edges of
the blades.
g)
Re-install the blades (if they were removed) and torque blade bolts to 75-
85 ft. lbs. (102-115 N-m). Be sure the spring disk washer cone is
installed toward the bolt head (See Figure 10).
CAUTION
- 22 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents