Procedure 3 Upholstery; Replacing Back Upholstery - Invacare Power 9000 Service Manual

PROCEDURE 3
This Procedure Includes the Following:

Replacing Back Upholstery

U
P
After ANY adjustments, repair or service and
H
BEFORE use, make sure that all attaching
O
hardware is tightened securely - otherwise
L injury or damage may result.
S
T
REPLACING BACK UPHOLSTERY
E
(FIGURE 1)
R
1. Remove one (1) armrest from the wheelchair.
Y
2. Cut the tie-wraps that secure the bottom of the existing
back upholstery to the wheelchair frame.
3. Remove the two (2) phillips screws and washers that
secure the existing back upholstery to the back canes.
4. Remove the two (2) hex screws, washers and locknuts
that secure one (1) back cane to the wheelchair frame.
NOTE: It is necessary to remove only one (1) back cane
to replace the back upholstery.
5. Pull the loose back cane out of the existing back
upholstery.
6. Pull the existing back upholstery up and over the
mounted back cane.
7. Install the new back upholstery over the mounted back
cane.
8. Slide the loose back cane through the new back up-
holstery.
The back canes MUST be securely fastened
to the wheelchair frame BEFORE using the
wheelchair.
9. Using the mounted back cane as a guide, reinstall
the loose back cane to the wheelchair frame with the
existing hex screws, washers and locknuts.
NOTE: Make sure the back canes are mounted to the
same height.
10. Securely tighten the new back upholstery to the back
canes with the two (2) phillips screws and washers.
11. Secure the bottom of the new back upholstery to the
wheelchair frame with tie-wraps.
12. Reinstall the armrest onto the wheelchair.
WARNING
WARNING
Washer
Phillips
Screw
Tie Wrap Mounting Hole
Washer
Hex Screws
FIGURE 1 - REPLACING BACK UPHOLSTERY
10
UPHOLSTERY
Back Upholstery
Washer
Locknuts