Invacare Power 9000 Service Manual page 37

FWD WHEELCHAIRS
NOTE: If motors are repositioned, the front riggings may
need to be repositioned. Refer to ADJUSTING/REPLAC-
ING TELESCOPING FRONT RIGGING SUPPORT in
PROCEDURE 9 of the owner's manual, 1080737.
FACTORY SETTINGS
MOTOR MOUNTING POSITIONS
SEAT
WIDTH 16
16 MIDDLE
18 MIDDLE
20 MIDDLE
USERS' WEIGHT 200 LBS AND UNDER -
MOTOR MOUNTING POSITIONS
SEAT
WIDTH 16
16 REAR
18 REAR
20 REAR
USERS' WEIGHT 201 TO 250 LBS -
MOTOR MOUNTING POSITIONS
SEAT
WIDTH 16
16 MIDDLE
18 MIDDLE
20 MIDDLE
NOTE: The front motor mounting position is reserved
for future applications.
1. Remove the battery boxes. Refer to INSTALLING/
REMOVING BATTERY BOXES in this procedure of
the manual.
2. Perform one (1) of the following:
A. WHEELCHAIR EQUIPPED WITH FLIP-UP
REMOVABLE FOOTBOARD - Remove the hex
screws and spacers that secure the battery tray
hanger bracket and footboard mounting bracket
to the wheelchair frame.
B. WHEELCHAIR NOT EQUIPPED WITH FLIP-UP
REMOVABLE FOOTBOARD - Remove the
front hex screw that secures the battery tray
hanger bracket to the wheelchair frame.
3. Rotate battery tray hanger bracket up.
4. Left side of wheelchair only - Remove the front
dust cover from the end of the crossbrace.
NOTE: Left is determined by sitting in the wheelchair.
5. Refer to charts in this procedure to determine the
proper mounting position that corresponds to the
user's weight.
6. Remove the six (6) socket screws that secure the
motor to the wheelchair frame.
7. Position the motor on the wheelchair frame at the
position noted in STEP 5 as shown in FIGURE 26.
SEAT DEPTH
17 18
MIDDLE MIDDLE
MIDDLE MIDDLE
MIDDLE MIDDLE
SEAT DEPTH
17 18
REAR REAR
REAR REAR
REAR REAR
SEAT DEPTH
17 18
MIDDLE MIDDLE
MIDDLE MIDDLE
MIDDLE MIDDLE
STEPS 2, 4, 10, 11, 12
Dust Cover (Not Shown)
Battery Tray
Hanger
Bracket
Hex Screws
Footboard
Mounting
Bracket
LONG Socket Screws (Apply Loctite 242 and
torque to 60-inch pounds) (STEPS 6, 8)
Wheelchair
Frame
SHORT
Socket Screws
(Apply Loctite
242 and
torque to 60-
inch pounds) Motor/
(STEPS 6, 8) Gearbox
MIDDLE MOTOR
MOUNTING POSITION
FIGURE 26 - REPOSITIONING MOTORS
37
PROCEDURE 8
Spacers
NOTE: It is not necessary to
disconnect the clutch handle
from the motor/gearbox.
FRONT MOTOR
MOUNTING POSITION
REAR MOTOR
MOUNTING POSITION
F
W
D
W
H
E
E
L
C
H
A
I
R
S