Fishman AGP-2 Installation Manual page 5

6. Mounting the Battery
Holder
The AGP-2 is supplied with a bat-
tery holder that can be attached to
the preamp cover with the screws
provided or be attached to the neck
block (see Section 6a).
Be sure to check and adjust the fit
of the battery in the holder before
installing the AGP-2 Preamp inside
the instrument.
6a. Optional Battery Holder
Mount
Cut a block of 1/4" plywood
approximately 1-1/2" x 2-1/2"
(40mm x 65mm). Using two
Number 4 pan-head sheet metal
screws (1/4" length), attach the bat-
tery holder to the wooden block.
The assembly can then be attached
to the neck block with wood glue,
double sided tape, or Velcro.
IMPORTANT: Although the supplied battery holder should provide adequate
capacity to grip the battery at all times, we strongly recommend removal of
the battery when shipping or flying with your instrument. FAILURE TO
REMOVE BATTERY COULD RESULT IN DAMAGE TO YOUR INSTRU-
MENT. Fishman will not be held responsible for any such damage as a result
of shipping or handling.
I n s t a l l a t i o n G u i d e
I n s t a l l a t i o n G u i d e
5
5