Ready To Play; Specifications - Fishman AGP-2 Installation Manual

AGP-2
AGP-2
Onboard Acoustic Guitar Preamp
Onboard Acoustic Guitar Preamp
11. Knob Alignment
The stacked knob set controls treble boost & cut (small knob) and bass boost & cut
(large knob). Both knobs have a center-detent to indicate flat position. Place the
bass (large outer ring) knob onto the stacked shaft so that the two inner protrusions
slide into the corresponding slots on the outer shaft. Now place the smaller treble
knob onto the inner shaft. The white position markers should align with each other in
the center detent position. Now place the large volume knob onto the appropriate
shaft; rotate the knob and remove to re-position the line if necessary for the desired
sight reference position.

12. Ready to Play

The power is switched on when a 1/4" guitar cable is plugged into the output jack.
The AGP-2 features a "soft" turn on mode. This means that the unit powers up grad-
ually over several seconds once the instrument is plugged in.
S
PECIFICATIONS
SYSTEM GAIN
Maximum input voltage before clipping with all controls at full boost
AGP-2 TONE CONTROLS
Treble: Boost and Cut
Bass: Boost and Cut
Frequency Response
ABGP TONE CONTROLS
Treble: Boost and Cut
Bass: Boost and Cut
Frequency Response
POWER SUPPLY
Battery Life
All specifications subject to change without notice.
9 dB (input to output at 1 kHz) All tone controls flat
.8V P-P
± 3dB at 1700 Hz
± 14dB at 20 kHz
± 3dB at 350 Hz
± 8dB at 50 Hz
20 Hz to 20 kHz ±2dB All tone controls flat
± 3dB at 850 Hz
± 14dB at 20 kHz
± 3dB at 350 Hz
± 8dB at 50 Hz
20 Hz to 20 kHz ±2dB All tone controls flat
9 Volts (battery not included)
150 hours continuous use (alkaline battery)
8
8