Selecting A Station; Preset Mode - Jensen VM9314 Operating Instructions Manual

16. BAND: Change between XM1, XM2 and XM3 bands
17. : View the SETUP menu
18. Touch this area to view the SOURCE MENU and select a new playback
source
19. MEM: View screen used to enter current channel into preset memory
20. PTT: Activate the Push To Talk voice recognition feature. See "iPod Voice
Control" on page 19.
21. LOUD: Turn the loudness feature on/off
Table 10: XM Radio Remote Control Functions
|| / BAND
|
|
1-9, 0
EQ
GOTO
PTT
Displaying the Identification (ID) Code
Before you listen to satellite radio, you must subscribe to the service using
your radio's identification number. To display the radio ID, touch the CH- or
CH+ buttons on the screen repeatedly to tune to channel "000". The screen
displays the radio ID where the channel name is usually displayed.

Selecting a Station

Touch the CH- or CH+ buttons on the screen to select a different station.

Preset Mode

To enter preset mode, touch the BAND button on the screen, or press the
BAND button on the unit (14) or remote control (20) to change between the
following bands: SAT1, SAT2, or SAT3 (indicated in the top left corner of the
TFT screen).
Six numbered preset buttons store and recall stations for each band. All six
stored stations (P1-P6) for the current band appear on the TFT screen.
Select SAT1, SAT2, SAT3 band
Previous channel
Next channel
Browse category
Browse category
Direct entry
Access equalizer menu
Access direct entry keypad
Push to talk
54
VM9314