Machine Preparation; Bare Floor Cleaning Technique - Bissell PowerWash Deluxe User Manual

O
peration

Machine preparation

1. Set up machine following instructions on
pages 6-9. Be sure to thoroughly rinse out
any remaining BISSELL advanced deep
cleaning formula from the Tank-in-Tank to
prevent slippery linoleum, vinyl, and tile
floors. Use BISSELL Hard Floor Solution in
the Tank-in-Tank.
2. Check ReadyTools dial - it should be set on
flooR clEanInG.
3. Plug into a proper outlet and turn power
switch ON.

Bare floor cleaning technique

1. Slowly move the machine nozzle with
bare floor tool forward and back over
soiled surface one time while pressing the
spray trigger.
caution: Do not over wet.
2. Repeat the motion without pressing the spray
trigger, using the bare floor tool to squeegee and
suction up the dirty water.
3. Repeat steps 1 and 2 backing along the
exit path.
4. Allow about 30 minutes for the floor to
dry completely.
5. When the cleaning job is complete refer
to the Maintenance and care section on
page 13-15 for machine cleanup and
storage instructions
6. To remove bare floor tool gently bend long
tab (right side) outward and pull tool down
away from nozzle. Rinse thoroughly, dry
and store.
w w w . b i s s e l l . c o m
11