SERIN
™
DECK MOUNT BATH FILLER
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Recommended Tools
Flat Blade Screwdriver
Adjustable Wrench
Channel Locks
*Supplied with Fitting
1
SPOUT ASSEMBLY
Install RUBBER RING (1) into ESCUTCHEON RING (2) and
place over mounting hole.
Insert SPOUT SHANK (3) through center hole of MOUNTING LEDGE.
Make sure that the RUBBER RING (1) is properly seated in RECESS
of ESCUTCHEON RING (2).
Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto
SHANK (3). From underside of ledge secure SPOUT (7) into position
with LOCKNUT (6).
2
4
6
Instructions
ROUGHING-IN DIMENSIONS
Tubing Cutter
*Wrench
*Hex key
Turn off hot and cold water
CAUTION
supplies before beginning.
7
RECESS
3
1
5
Installation
2064.90X
9-1/2"
9-3/4"
(240mm)
(247mm)
2-3/4"
(71mm)
6-3/4"
(170mm)
MOUNTING
SURFACE
1-1/8 D.
1-3/16" MAX.
(30mm) MAX.
3/4-14 MALE
N.P .T. INLETS
2
PREPARE TUBE AND TEE ASSEMBLY
Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
VALVE (2) location (between 6-1/2" and 12"). If necessary,
cut and/or bend TUBING carefully. Make sure tube bend is
close to the TEE (1) so that it will not effect the compression
joint at the VALVE CONNECTION.
Remove COUPLING NUT (3) and FERRULE (4) from each
VALVE (2) and slide onto TUBING (5).
MOUNTING
SURFACE
Certified to comply with ANSI A112.18.1M
6-1/2" to 12"
(165mm to 305mm)
3-1/4" D.
(82mm) D.
(C)
(H)
12 MAX.
1-1/16 D.
(305mm)
(27mm) D.
4
3
6-1/2" to 12"
(165mm to 305mm)
M 9 6 8 8 3 0 R e v . 1 . 4
2" D.
(52mm) D.
2-1/16" D.
(52mm) D.
3'
(76mm)
1-1/2 MAX.
(38mm) MAX.
1-3/16 D.
(30mm) D.
1
5
3
4
MOUNTING
SURFACE
2
NOTE
VALVE inlet is
3/4-inch NPT male.