Table of Contents
Advertisement
7. Serial ATA RAID connectors (7-pin SATA_RAID1, SATA_RAID2)
These Serial ATA connectors support SATA hard disks that you may
configure as a RAID set. Through the onboard Promise
RAID controller, you may create a RAID0, RAID1, or RAID0+1
configuration. Configure the onboard device and SATA items in BIOS
to use the RAID feature. Refer to page 4-17 fro information.
NCCH-DL SATA RAID connectors
8. Backplane SMBus connector (6-1 pin BPSMB1)
This connector allows you to connect SMBus (System Management
Bus) devices. Devices communicate with an SMBus host and/or other
SMBus devices using the SMBus interface.
NCCH-DL SMBus connector
2-30
SATA_RAID1 SATA_RAID2
SATA_RAID3 SATA_RAID4
BPSMB1
1
Chapter 2: Hardware information
®
PDC20319
Advertisement
Table of Contents
