Table of Contents
Advertisement
PROBLEM
The transceiver does
• The battery is exhausted.
not turn ON.
• Bad connection to the battery pack.
No sound from speaker. • Squelch level is too deep.
• Volume level is too low.
• Speaker has been exposed to water.
Transmitting is impossi-
• Some channels are for low power or re-
ble, or high power can
ceive only.
not be selected.
• The battery is exhausted.
• The battery over charged.
• The output power is set to low.
The displayed channel
• Lock function is activated.
cannot be changed.
Scan does not start.
• "TAG" channels are not programmed.
No beeps.
• Beep tones are turned OFF.
Self check error.
• The temperature is outside of –25°C to
(Temperature)
+65°C; –13°F to +149°F (approx)
Self check error.
• The connected battery pack's voltage is
(Battery voltage)
more than 11 V.
Self check error.
• Water has entered the transceiver.
(Water intrusion)
POSSIBLE CAUSE
TROUBLESHOOTING
SOLUTION
• Recharge the battery pack.
• Check the connection to the transceiver.
• Set squelch to the threshold point.
• Push [+]/[–] to set a suitable level.
• Drain water from the speaker.
• Change channels.
• Recharge the battery pack.
• Verify the battery voltage is correct.
• Push [H/L•
] to select high power.
LOCK
• Push [H/L•
] for 1 sec. to cancel the
LOCK
function.
• Set the desired channels as "TAG" channels. p. 15
• Set the beep tones to ON (Fix Beep/User
Beep) in SET mode.
• Leave the transceiver at room temperature
for a while. Turn the power ON to check if the
internal temperature has returned to normal.
• Verify the battery voltage is correct.
• Have the transceiver checked at your local
distributor or dealer to see whether the
transceiver works properly or not.
10
REF�
p. 23
p. 3
p. 10
p. 10
—
pgs. 8,
9, 30
p. 23
—
p. 11
9
p. 13
10
p. 18
—
—
—
29
Advertisement
Table of Contents
