GBC 54C Installation & Operation Manual page 31

SPIRE II Series – Installation and Operating Instructions
(1)
Main
Roller
Feed
Table
Main
Roller
(2)
Printed media or mount adhesive
Figure 40. Cutting film from the laminator diagram.
5. Carefully cut the remaining top film web and
release liner between the idler bar and Main
Roller (2).
6. Carefully cut the film web between the lower film
supply and the idler bar (3).
CAUTION: Be careful to not cut the rollers.
7. Adjust the gap of the Rollers.
8. Carefully grab the web (top and bottom film),
from the front operating position and pull
towards you.
Rewinder
PSA Laminate
Idler
(1)
Idler
(2)
Rewinder
Pull
Main
web
Roller
Feed
Main
Table
Roller
Idler
Printed media or mount adhesive
Figure 41. Pulling remaining web from the laminator
diagram.
9. Do not allow the adhesive side of the film to
contact the Main Rollers.
PSA Laminate
Idler
Page 6-7