GBC 54C Installation & Operation Manual page 29

SPIRE II Series – Installation and Operating Instructions
16. Raise the Upper Main Roller and press the
Footswitch to smooth out wrinkles in the film.
17. Install the Pressure Plate.
W F
eBBInG Ilm By
F e
Ilm to xIstInG
The following describes a method for threading film
whereby the existing film on the rollers may be used
in place of the threading card to draw the new film
through the laminator. Leading edges of the new
film will be overlapped onto the adhesive of the old
film. The existing film and the new film will be pulled
through the laminator together.
Caution: Press STOP to ensure the machine is not
running.
NOTE: In the following illustrations, depending on the
laminator model, you may or may not have Pull rollers
and the Feed Table either pivots or is removable.
To tack new film to existing film:
1. Press STOP.
2. Remove the Pressure Plate.
Refer to the "Removing the Pressure Plate"
section.
3. Remove the Feed Table.
Refer to "Feed Table" section.
WARNING: Removing the Feed Table exposes
moving parts. This means you can be harmed when
the Feed Table is removed. Make sure to replace the
Feed Table when film loading is completed.
Rewinder
(1)
Main
Roller
Feed
Table
Main
Roller
(2)
Idler
Printed media or mount adhesive
Figure 38. Cutting remaining web diagram.
t n
ackInG eW
F
Ilm
PSA Laminate
Idler
(2)
Page 6-5